Page 25 - Bendix Air disc brake-01

The Tappets (13) can be removed from the Threaded
Tubes by using Wedge Fork A. (Order No. II32202).

Remove the old Tappet Bush (116). A

Check Inner Seal (arrow) and if damaged, replace the
Caliper. 13

A 13
7.1.1 Adjuster thread inspection

Place an new thickness Pad (12) into the outboard
gap to avoid overrunning of the Threaded Tubes.
161
VF 00127/4

IMPORTANT!
12
Threaded Tubes should not be extended
beyond thread engagement of the Bridge. 16
If thread engagement (synchronization) is
lost, the Caliper must be replaced.

For the inspection of the threads, the tubes must be 46
screwed out (max. 1.2in. [30mm]) by turning the Adjuster
(23) clockwise.
M+P-KN-019
If Caliper is not installed on axle, put a spacer E
(length = 2.76in. [70mm]) into the Caliper (1) to avoid
overrunning of the Threaded Tubes (16) when adjusting
70 mm
them out (see illustration opposite). During adjusting,
the threads can be checked for corrision damage.
In case of water ingress or corrosion, the Caliper
must be replaced.
E
16

7.2 Tappet with Boot installation

With Caliper fixed to axle:
Grease threads with RENOLIT HLT2 (Order No. 1
II14525).
VF 00127/13
Screw back Threaded Tubes (16), by turning the
Adjuster (23) counter-clockwise. B

Place new Tappet Bushing (161) onto the head of the
Tube (16).
161
Sealing seat in the Caliper for Tappet with Boot (13)
must be clean and free of grease. 13

Place Tappet with Boot (13) onto the head of the
Tube.

Use Push-In Tool with the short strut (B)
(Order No II19252) for positioning and pressing-in the
Boot (13).
VF 00127/5

25
SD-23-7550: 000: US: Released: Wed Apr 09 01:32:27 CEST 2014: