Page 31 - KNORR Pneumatic Disc Brake

7

Tappet and Boot Assemblies (13) and Inner Seals (22) Replacement

7 Tappet and Boot Assemblies (13)
and Inner Seals (22) Replacement
(A)

For ease of reference, each component of a tool is referred T15
to by an identification number e.g. (T28); a complete tool
(containing one or more such components) has been given
a letter code e.g. (E) - see section 2.1.

To remove the tappet and boot assemblies (13) use the
wedge fork (A) (see Fig 7a). 7a - Tool for replacing the tappet and boot assemblies

(B)
To fit the tappet and boot assemblies (13), use tool (E) (see T03 T04 T01 T24
Fig 7b).

Note: Older versions of the tool kit were supplied with tool
(B), which in this case, can be used instead of (E). Refer to
the service manual included in the old service kit.
T02
Tool component (T55) is necessary to service the brake
types SL7 and SM7 (see also service manual Y081564). (E)
T03 T04 T28 T55 T56

1
To fit the inner seal (22), use tool (L) in configuration (L ) when
2
the caliper is mounted on the vehicle or configuration (L )
when removed from the vehicle (see Fig 7c). T02
7b - Tool for fitting the tappet and boot assemblies

(L)
T03
(L ) (L )
2
1
T04
T03

T09 T09

7c - Tool for fitting the inner seal

31