Page 47 - KNORR Pneumatic Disc Brake

10

Guide Pin Bush/Sleeve Replacement

10.2.1. To replace the rubber bush the following tool combi- (R) Tool combination to press-out
nations are used depending on the variant: rubber bush (6a and 6b)
T21
T06 (Ø 39 mm)
Washer
Rubber bush (6a and 6b) requires tool (R) for removal and DIN 125
assembly (see Fig.10.2.1.a). T20
T22

T18
T19
Grub screw
DIN 915
Tool combination to
press-in rubber bush (6a and 6b)

10.2.1a - Tool (R)

Guide sleeve (6c) requires tool (N) for removal and assembly (N) Tool combination to press-out
(see Fig.10.2.1.b). guide sleeve (6c)
T21
Washer
DIN 125
T20
T14
T05
(Ø 35 mm) T06
(Ø 39 mm) T08

Tool combination to
press-in rubber bush (6c)
10.2.1b - Tool (N)

Rubber bush (6d) requires tool (C) for assembly only and (C) Tool combination to press-out
fitted with (T06) instead of (T08) (see Fig.10.2.1.c). rubber bush (6d)

Note: The rubber bush (6d) is removed at the time the T06
cover (68d) is removed (see Section 8.1.4). Therefore no T10 T07
special tool for the removal process is required.

Washer
DIN 125

10.2.1c - Tool (C) with (T06) instead of (T08)

47