Page 44 - KNORR Pneumatic Disc Brake
P. 44
9
Inner Boot (9) Replacement
9.11. Check correct fitment of inner boot (9) by carrying
out a pulling test (see Fig.).
9.12. Grease brass bush (7) and, if installed, guide
sleeve (6c) or rubber bush (6d), with white grease (Part
No. II14525 or II32868).
9
9.11 - Carry out pulling test on inner boot
9.13. Fit guide pin (5) and if necessary guide pin (4)
(see Fig.).
5
9
9.13 - Fit guide pin
A
9.14. The lip in the end of the inner boot (9) must engage
in the groove of the guide pin (5) and, if installed, in the
groove of guide pin (4) (see Fig. arrow A).
9
58 5
9.14 - Lip of inner boot engages in groove on guide pin (arrow A)
9.15. Push on the ring (58) to secure engagement of
boot (9) in the groove of guide pin (5) or, if installed, in the
groove of the guide pin (4) (see Fig.).
9.16. Fit brake caliper to carrier (see Section 8.2). 58
9.15 - Push on ring (58) to secure boot in groove of guide pin
44

